Topic: Airserv-ng problem
I got a quick question regarding the installation of the commview drivers. I extracted the packet, manually installed the drivers, but there is a problem. The drivers installed OK but when I try to run the commands it says "adapter not found." I have an proxim oronico 802.11a/g combocard silver 8481, so everything was set with that, but when I go to load the command prompt it says the following:
C:\Program Files\Aircrack>Airserv-ng -d commview.dll -p 12345 -c 6 (the testing command at the tutorial screen)
Opening card commview.dll
Adapter not found
airserv-ng: wi_open(): No error
then it goes back to the prompt.
As far as I can tell, the adapter is installed correctly and zero config is disabled, as well as my other wireless card and my RJ45 network card as well. (I enable to the hardwired card to go online and type this).
Does anyone know what the problem could be and what I might do to fix it?
Thank you all very much!